New Allstar Node Software

Objective:  Upgrade Allstar from hamvoip 1.02/1.7 to latest 1.5 version.  This is not a cookbook.  It is a narrative.

Issue: No Wired Internet, tether or Router/Switch by which to get an IP to be able to Putty into the PI

What I have:  Smartphone w hotspot for internet but the Pi is not natively activated for wireless.

Before we digress too far a few prerequisites could be in order if you have an existing node. The listed below will help considerably.

• Read out your existing simpleusb.conf file and cutnpaste to whatever computer you are using.  Then save the file: I did and was glad.
• Know that you will be asked whether you want to Install Asterisk or Not. I said Yes
• Have your existing node number and password from Allstar.org.

My Solution: I borrowed an old Linksys router with a 4 port switch. Activate the Router and plug your computer into the LAN switch side and make sure you can get into the admin of the router.  Enter the Admin of the router (usually, 192.168.1.1 or 192.168.0.1) enter the user name and password.  Look for something like LAN Clients that shows the currently attached LAN devices.

Now, attach the Pi 3 to Router LAN switch and power on the Pi 3 with the Allstar 1.5 version image installed on the microSD.  Refresh the display monitoring the Router admin LAN client section.  You should see the Pi 3 IP Address that may look like 192.168.1.xxx.

Next Putty into 192.168.1.xxx:222 using root and password root. When you do this you will be presented with a screen asking if this is the First Time run.  If it is then answer yes. This will result in a series of questions you must answer and for which the above prerequisites will com in handy.  At some point the questions will end with a reboot request.  ( I use Bitvise which is a very nice free integrated SSH/SFTP client).

When the reboot occurs and the putty is reconnected. a “new menu” will be presented.  Of the whole list the most important will be the wireless activation (remember the router is still connected).  Go to the Wireless section and go to it.  This will result in a search for  wireless networks nearby so you will need to chose one and connect to it with the necessary credentials(usually a wpa2 password).  After this is successful you will need to reboot the Pi.  As soon as you start the reboot, disconnect the wired cable from the router (this is important to do this quickly).

When the router has rebooted it will announce the IP and if everything was done correctly the wireless IP will be announced.  Now you can putty in with the new IP and modify whatever is desired.  In my case I went to /etc/asterisk and copied simpleusb.conf to simpleusb.conf.xxx.  Then I edited by using nano simpleusb.conf.  I did this because I entered the incorrect configuration data from the menu. I was not ready with config data on usb or usbinvert.  If you do change anything be sure to cntl-O and then cntl-X out of the edit node.

After this I entered the “new menu” and selected simpleusb tune menu and set the Rx & Tx levels.  When done I put out a test call and all levels were good.  All in all, it was a reasonably seamless upgrade.  It is nice to be able to enter the CLI from the menu.